https://www.posetteforever.com/viewtopic.php?f=64&t=2609&p=33765#p33765
-----------------------------------
manleystanley
Saturday, 02 December 2006, 04:52 PM

Re: Introduction
-----------------------------------
Need to figure out the proper key phrases.

Working on redoing a Make huanm figure. I had it boned and in order to do wieght mapping in Carrara 5 I had to convert to vertex modeling. I had done a Hex2 2x smoothing on the mesh and when it was converted to vertex the poly count was to massive to work the mesh. So I had to start again at the base figure model, and am reboneing it today.  :sad:


