https://www.posetteforever.com/viewtopic.php?f=1&t=1549 ----------------------------------- messenger Tuesday, 12 July 2005, 07:23 PM help with poses ----------------------------------- Ok...I know you guys use mostly posette but I know some of you also use other models occasionlly like V3 etc...my problem is I did some poses for her and saved them to my pose folder. When I tried to check them out applying them they were all messed up ..they were all upside down or turned around although the actul pose was still there they were just not in the right position on the screen. Can anyone help here...am I supposed to save the morph channels when I save the pose? help I really am ready to pull my hair out on this one ----------------------------------- Tormie Tuesday, 12 July 2005, 08:09 PM ----------------------------------- Are you using Poser 6? if yes go to preferences and turn off the "use external binary morph targets" in the "misc" section... When you save a pose you can even select a subsect of the body parts, it can help finding what's wrong... ----------------------------------- messenger Tuesday, 12 July 2005, 08:18 PM ----------------------------------- no davide I am using propack....I am more comfortable with it and I find 6 too confusing ...after all I am blonde..hehehehe ----------------------------------- Tormie Tuesday, 12 July 2005, 08:29 PM ----------------------------------- :mmmh: :mmmh: :mmmh: Try turning off inverse kinematics before saving the pose... ----------------------------------- PitKlad Tuesday, 12 July 2005, 10:25 PM ----------------------------------- or your original pose had the body moved to the thubnail pose by body When you make a pose start from the hip with IK off make the rotation you want to have and then pose the other parts too... The changes on the body x,y,z and rotation will not be stored in a pose... ----------------------------------- messenger Tuesday, 12 July 2005, 11:28 PM ----------------------------------- ok...I think I know what I have to do now...thanks narcissus that is what I needed to know I have been moving the rotation dials to position the body...I will try a different approach now and see if that works..runs off to kill V3.....arrrrgghhh