https://www.posetteforever.com/viewtopic.php?f=1&t=1362&p=20170#p20170
-----------------------------------
Visitor
Sunday, 03 April 2005, 02:08 AM


-----------------------------------
It sounds like your modeler did not preserve or properly adjust the UV Mapping.  Unless there is some function in that software to preserve that information across the operations that you performed on the model, you will need to create a new UV Map for the model.

As for the joints:  Are you using the new OBJ file with the original CR2 files?  If so, they are calculated to work with the exact polygons of the original geometry.

You will need to create a new CR2 file with a new set of joint parameters.  The procedure that you can follow will depend on with version of Poser you are using.  If you have Poser 5 and I believe Poser 4 PP, you can inport the new OBJ file and enter the setup room to attach a bone structure to the model, there by creating a new Poser figure.  By the way, in the process you have lost access to NEA's morphs.  Depending on how you altered the geometry, you may be able to use some of them, but I have not checked the license for the morphs, to determine if you are permitted to reuse them this way.

If you have Poser 4, then you will have to use the older Poser 3 figure setup procedure, which is also still useable with Poser 5, if you don't like the setup room.  The instructions for that procesure should be on your CD.

Pangor