https://www.posetteforever.com/viewtopic.php?f=1&t=2467&p=33106#p33106
-----------------------------------
melamkish
Thursday, 19 October 2006, 02:43 AM

Re: file conversion
-----------------------------------
I just opened your CitygenV0.9.wrl file using vrml in my CAD program, exported it as a 3ds file and successfuly opened it in Poseray.  The file openes upside down, but that should not be an issue. I also imported the 3ds file into poser, it would appear successfully, but the exported obj will not open in my modeling program.

Further checking in my CAD shows that the entire city is one group, with no individual points or lines.  Also in Poser, at a reduced scale of only 1%, the city was extremely large.

This is begining to intrigue me, so will play a bit more and see what I can figure out over the next few days.


