https://www.posetteforever.com/viewtopic.php?f=34&t=3908&p=44806#p44806
-----------------------------------
Nik
Tuesday, 22 March 2016, 12:39 AM

When Is A Door Not A Door ??
-----------------------------------
When is a door not a door ??

When it is an inch off, and I can't figure what I did wrong...

IIRC, I had some trouble last time with 3D Booleans, when turboCAD refused to recognise a 'cutter' as a valid object after it had been moved and rotated. There are work-arounds, which I'm rediscovering piece-meal, but I've had a lot of trouble making doorways. This stair-well came out okay, as I just cloned and stacked modules. Repeating the door-way cutting with a test wall & room became a horrible, horrible mess. 

Try again tomorrow...

 [img]http://www.posetteforever.com/files/posted_images/680/clipboard03a.jpg[/img]