Hi, any experience of Hexagon 2 ??
Now Hexagon has migrated to v2.5, the v2.0 has appeared on a 3D mag cover disk...
I've had a quick look at Hexagon pages on eg D*Z site, noted the program seems able to I/O both 3DS and OBJ, do un-wrap, booleans etc etc etc.
I've not tried it, but the layout and tools seem more 'Trad CAD' than 'Organic modeller', which suggests I may, possibly, be able to operate it...
Thoughts ??
Hexagon 2
| Hexagon 2 |
| Article | |
|---|---|
 Hexagon 2 |
|
|
|
|
|
|
|
 |
| Hexagon 2 |
| Comments | |
|---|---|
|
Re: Hexagon 2 |
|
|
I have had Hexagon 2.2 and you will want the update from 2.0 because it is unstable in some areas. It is a
pretty good modeler even though I have not used it in boolean mode. If it is free then you have nothing to loose and hours of fun figuring it out. Very good software. :thumb: |
|
|
|
|
| |
|
Sleep Deprived: Regret 'free' Hexagon Is 1.2 NOT 2.1... |
|
|
D'uh, I really, really need more sleep...
The cover-disk program is v1.2, NOT v2.1. Still got a nice set of tools, still going to give it a try... |
|
|
|
|
| |
 Was this topic useful? |
|
Page 1 of 1 |
Users browsing this topic: 0 Registered, 0 Hidden and 1 Visitor Registered Users: None |